What have you been up to this week

[John Abbott]

Good job Marty...Will keep unwanted fingers from just walking off with gear as well..!! I've heard that you you get all the chicks..and there's proof!!!!

[LS120]

just did a deal for a new un-made 15meter x 6meter x 2.8meter shead.. $3000.00 all up kit set with all the bits.

just need to get planning permision now..

 

[Marishka]

thnx ben,
haha , yeah john,o id rather the unfeatherd kind though.
shakeira lookin kind will do.   

[John Abbott]

Well, this week i finally started cladding my shed with colourbond sheeting. I should hopefully have it finished by new year..

[Marishka]

lookin good Johnno,
bet ull be happy as when its close up stage,
bet ur missus will never get u outa the shed, lol.
magick

[John Abbott]

Yep Marty... can't wait....   Been a long time comming

[Bullstik]

thats looking good, whats the over all size of it

[John Abbott]

10 meters long....5.6 meters wide... and 3.1 meters at the highest point.    Mind you... yesterday i had a look at some factory units being built near me in a industrial park and they were bloody huge inside with an office and mezzanne floor and dunny upstairs god knows what the asking price would be but it was very pretty.........oooooo  come on powerball!!!!!

[obsession]

about to attempt a high speed diff conversion ,borg warner center bedford stud pattern.

[kimbosound]

Just finished stripping the old donor van for bits for the truck....got heaps of spares - steering column, wiper motor assembly [intact] all the dash brackets, front end, tranny [motor is shot] wiring looms, bonnet hinges, brake booster and master cylinder and brake pedal assembly,....the list goes on.....it is basically a bare shell now.....will post a pic before i leave Narrogin later on today. Heading back to Albany with all my booty.....i will be working on the truck over the xmas break and hope to have it in white paint ready for rego......fingers crossed