diff.....icult!

[SkippyThBushKangeroo]

well axle tapers looked like they had not worn or created a lip where bearing sits will get away wiv the ol punch a few grab spots on it saw in thread someone mentioned putting toyota retaining rings on as they held firmer..anymore info on that as in which model tojo  retaining ring to use . and  where to purloin em from... wivout buying whole tojo bearing ass.....or can one spread the retainers of the new bearing first before fitting to ensure max grip...thanks for any input to this request..cheers skip 

[Dano]

Hey Skip, I found some old part #'s but just confirm that they're 9" or Borg Warner(b4 u buy ), as there's no date on the invoice..........


" to suit FORD, rear wheel....KIT F205A"    1966-72, XR XT ZA ZB - 8CYL
              XW XY ZC ZD -351 FALCON,FAIRLANE
              1972-79 (DRUM BRAKE) XA XB ZF ZG 5.8 LTR

CONTAINS BEARING,RING& SEAL FOR ONE WHEEL.


good luck Dan

[SkippyThBushKangeroo]

googled the kit no..it only comes up in some yank website.. no chance it has the manufactures name withn it?? verniered the bearing comes in at inn dia 35mm out dia 80mm width 37mm... is sealed  thamks

[SkippyThBushKangeroo]

well.... copulate my antiquated footwear!!! after phonin around a few places re bearings .. woz in pirie yesterday stockin up on supplies an stuffin me pouch wiv the best indian takeaway this side of the flinders i thought(unusual).. would pop into autopro ( the automotive version of cheap as chips ) an see if they could match the ones i had.. i woz pesimistic to say the least,.but to my suprise they said they had them in stock in their adelaide store an could have em in next week . i remembered wot dano had said & asked them to make sure they were for a 9 inch or borg warner then, tentively popped the question...how much??... $61 each they replied. order em in i  . will let u know if they in fact are the ones or wether they have been pullin my puddin about it . many thanks again for all yor inputs into this thread guys u all are truly invaluable to the wonderful world of beddying.

[Dano]

nice one Skip.....

[Dano]

just found this note..... sorry Skip,hope you havent paid for yours... Again from CBC I'm sure:

rear wheel bearings for 9" galaxie F-208A-KK

[ben]

Diff widths
By hq_ss. 10/01/09@09:46 Shed LetsCruise 6110

These are a few I have but I am not 100% sure on these so I am open to corrections and the ? marks are on ones that I have conflicting numbers on.

Flange to flange measurements

EK 55.90" 1420 mm

HR 57.08" 1450 mm
HK 60.47" 1536 mm ?
HT/G 61.02" 1550 mm ?

LJ 53.93" 1370 mm
LH 56.69" 1440 mm
VN 1550 mm or 1560 mm ??

XR-XY Falcon 59.05" 1500 mm
XA-EL 61.02" 1550 mm
EB 61.22" 1555 mm

Cheers Paul.


pulled off old holden site..


shane can we move this post into the diff section please?

cheers
ben

[SkippyThBushKangeroo]

well spotted ben    shouldnt be too diff.. icult to do shane ?? cheers