Sealing old revit holes

[walzaher]

Hi everyone,

I have been searching but havent been able to find any answers. Today i took out the old board on the back of the van so i can clean under it, sand it down and insert it again and lay carpet over it. It had pop rivets holding it. After the horrible job of removing them, I am wondering what I can do to stop the holes where the revit pins were from starting to rust?

Thanks very much
Waseem

[Warren]

paint or otherwise seal any bare metal surfaces. If your concerned with water getting in through the holes then seal them up with a clking compound (after youve painted them).

Warren

[Dano]

several options, use metal screws to re install floor(you can dip them with wax), tin snip little plates and glue with a silaflex type bond adhesive , weld of coarse, re rivet with larger rivets, but all in all once the floor is refitted, simply coat the fitting you use, either paint and or under body sealer/ it also is a sound deadner. Dano.

[walzaher]

thanks for the advice =) very helpful!