BUGA Community

sorry me again,

can we just use a bedford jumbo diff  on the rear?? would this work with the 202?

thanks again 

Hello all thank you for the great replys and welcomes im very excited,

Jeff i was just wondering is the 6 cylider diff like a holden one? to match the engine? this might be a really stupid question sorry but im just learning,
also i spoke to you a whilte ago on the phone when i forst bought my bedford and you were hoping to get kits made up have you been able to do this or not yet i remember you saying it would take a few months,

any idea where i can get the pop top from my roof has the allowance but no fabric?

thanks all for the messages.... will keep in touch 

Hey There  ,

I am new to this site so bear with me a bit  still cant work out how to post stuff fingers crossed this works..... i have just bought a CF bedford as a project and really dont know anything about cars (i know its stupid but got to start somewhere) we are going to re power it with a holden 202 Moter, as at the moment it has the standard 2.3 slant 4 and it has seized (before i bought it)....... i hopefully have found a engine but just need the engine mounts, cross member, drive shaft and anything else anyone can suggest i will need..... also am finding it really hard to find some wheel studs here in little NZ was wondering if anyone out there could help me with this?

this is my dream vehicle and i really want to do it right but girly (sorry to all the guys out there cringing at this comment)

thanks 

Benita