BUGA Community

Hi I have a VN-VP Holden motor in my Bedford Van, I need to renew the fuel Pump and Filter, but not sure what has been used (photos attached) looks like a (EFI VK Fuel Pump, mount and Dampers) which would make it a 3.3 L , the current setup seems to work ok, as far as supplying fuel goes, also looks like it has a regulator of some kind attached as well, I think it is still the standard Bedford Tank as you can see in the photos it has two pipes from the tank, so I guess one is a return, so the Bedford tank may have been modified to some degree. Does anyone know what this pump etc is out of, Holden for sure.. Or any ideas what I could replace it with that would suit the VN Motor. Thanks….

Today I touched my van and liked it ....  muhahaha

I would say so, it's been a good year..

Will have a look, have a spare pkt here, OD the same but inside bush had to be drilled out by 2mm it has a thick wall so plenty of meat left.. can't remember how thick inner tube was but the thickness is greater than the original one after been milled... and the rubber bush had to be shorted a little, cut a little of the inner side. as it was wider than the shackle

 .

Can someone also tell me if their Standard Factory Single wheel Jumbo diff is mounted under the springs or on top or was this just on the Dual Wheel model, top mounting. Thanks