BUGA Community
Technical => Driveline => Topic started by: ehwagon64 on January 29, 2012, 04:37:50 PM
-
hi can any one tell me what wheel adapters i need as i have hq frontstud pattern and would like to change back end to put my mags on i have 120.6 hq and 152.4 for beddie if this is correct where do i buy them from thanks ehwagon64
HI SORRY FOR CONFUSION I WANT TO CHANGE BEDFORD STUD PATTERN ON REAR END I WANT TO TAKE THIS TO HQ STUD PATTERN AS I HAVE SET OF DRAGWAYS THAT R HQ STUD PATTERN AND LOOK EXCELLENT ON MY BLACK CF BEDFORD
-
mmmmmmmmmmm........... interesting you wanna go back to bedford pattern are you running discs on the front? if your rear end has been re-drilled you could remove and re-stud not sure wheel adapters are a safe move.
-
pull both rear axles out and hubs take them to an engineer and have them re-drilled to hq pattern then .
easy as
-
got mine from mr mag morley..
-
pull both rear axles out and hubs take them to an engineer and have them re-drilled to hq pattern then .
easy as
I did this on the front, had hub and drum re-drilled for hq.
One problem though, the centre bore hole (on the front at least) need to be about 91mm which is big. i Had to get my mags machined out to enlargen them from 76mm to 91mm. only had them machined to half the depth so i could still fit the centre caps on the front. See my gallery for details
-
pull both rear axles out and hubs take them to an engineer and have them re-drilled to hq pattern then .
easy as
I did this on the front, had hub and drum re-drilled for hq.
One problem though, the centre bore hole (on the front at least) need to be about 91mm which is big. i Had to get my mags machined out to enlargen them from 76mm to 91mm. only had them machined to half the depth so i could still fit the centre caps on the front. See my gallery for details
if your dong this i would encourage you to fit falcon studs at the same time. larger and much stronger than hq studs..