BUGA Community
Technical => Driveline => Topic started by: BusyKiwi on September 18, 2010, 06:58:54 PM
-
Anyone (prefer in kiwi land but am open to postage from oz) got any old Holley carb parts laying around?
Am after a base plate for a 1850-2
It has to be a 1850 model as they all have different sized secondaries.
Can pay cash, paypal or swap another base plate or Holley parts or whatever
Cheers
-
i got a holley in bits in the shed,
is it a spreadbore your after with vac secondaries or a mech squarebore?
i found this one Busy , if its what ur lookin for its yours.
the shafts are nice n tight 2, no play or wobble in them. just needs a clean.
ill give it a clean n throw it across the ditch if its what ur after.
regards marty
(http://i290.photobucket.com/albums/ll265/marty23121961/P1015403.jpg)
(http://i290.photobucket.com/albums/ll265/marty23121961/P1015402.jpg)
(http://i290.photobucket.com/albums/ll265/marty23121961/P1015404.jpg)
-
Thanks Marty but it's a square bore with vac secondaries I'm after.
I brought the carb from ebay a while back, tried it and the vacuum was blocked, closer inspection showed the corner had been broken off and they resined it on via the main vac tube, take the resin out and the corner fell off
-
sorry i couldnt help , its a spread bore ive got.
if u lived close by i coulda dusted off my aluminium welder and reatached the corner properly for u brother.
anyway cheers hope u get it sorted
marty
-
Hey Busy
Have you got a photo of what you are after I have about 6 old hollys in the shed I have collected over the years but I don't know much about them so need a picture to rule mine out
Cheers
Joe
-
Thanks to everyone, I managed to find one. cheers